New concrete must cure for a minimum of 30 days. To see more about applying this product please visit http://www.behr.com/behrx/act/view/.... I hope this helps.

Behr's 2-Part Epoxy finish can be applied on any interior concrete project. This product would not be recommended if the balcony is exposed to exterior weather conditions.

Yes it can. Hope that helps

The existing paint needs to be removed. Depending upon the job itself this may be accomplished with a scraper, pressure washer, chemical means, or a combination thereof. After the existing paint is all removed then just follow the directions on the Premium 2-Part Epoxy Garage Floor Coating for preparation and application.

This garage floor coating will cover about 200-250 square feet per gallon.

It will not be necessary to sand the surface prior to using the Epoxy Kit.

Behr's 2-Part Epoxy will not adhere over oil/grease stains or over an existing oil base coating. To ensure adhesion remove severe oil and grease stains with BEHR No. 990 Concrete Cleaner & Degreaser, follow BEHR No. 990 with BEHR No. K-109924 Concrete Cleaner & Etcher (included in the kit). Allow the surface to dry before applying Behr's Premium 2-Part Epoxy.
Source: BEHR Representative

Behr No. 95536 2-Part Epoxy can be applied over a pre-existing coating as long as the old coating does not have a sealer on it, isn’t an oil-based coating, and is not cracked or peeling. The surface should be wire brushed to create more surface area for the Epoxy to adhere to, and it should also be given ample time to cure before it should be driven on. Typically 7 days is enough time, but because it is applied over a pre-existing coating,you should park on corrugated cardboard for the first 30 days.

Behr No. 95536 2-Part Epoxy Paint can be applied to a basement floor so long as there is no sign of hydrostatic pressure coming up through the concrete floor. The epoxy paint has a built-in non-skid element to the paint, which helps to prevent slips and falls. Make sure that the concrete patching compound has been allowed to cure before the epoxy is applied over, and also make sure that the entire surface is etched properly beforehand. The etching will neutralize any alkalinity in the patching compound, and allow the epoxy to bond to the concrete securely.

Behr 2-Part Epoxy can be applied to a previously coated surface so long as the previous coating is in sound condition. If there are no signs of peeling, then the surface should be wire brushed and wiped clean with a moist towel prior to applying the epoxy.